1-1. MOUNTING METHOD
The panel of the LCD module consists of two thin glass plates with polarizers which easily get damaged since the module is fixed by utilizing fitting holes in the printed circuit board. Extreme care should be taken when handling the LCD modules.
1-2. CAUTION OF LCD HANDLING & CLEANING
When cleaning the display surface. Use soft cloth with solvent (recommended as below) and wipe lightly.
-Isopropyl alcohol
-Ethyl alcohol

Do not wipe the display surface with dry or hard materials that will damage the polarizers surface.

Do not use the following solvents:
-Water
-Ketones solvents
-Aromatics solvents
1-3.CAUTION AGAINST STATIC CHARGE
The LCD modules use C-MOS LSI drivers. So we recommend that you connect any unused input terminal to Vdd or Vss, do not input any signals before power is turned on and ground your body, work/assembly table and assembly equipment to protect against static electricity.
1-4.PACKAGING
Modules use LCD elements, Do not subject to excessive shocks by dropping the units.
-To prevent modules from degradation, do not operate or store them in sunshine or at high temperature/humidity.
1-5.CAUTION FOR OPERATION
It is indispensable to drive LCM within the specified voltage limit since the higher voltage than the limit will shortens LCM life.
Response time will be extremely delayed at lower temperature than in the specified operating temperature range and on the other hand at higher temperature LCD will show dark color in them. Page Down